Product parameters:Material:Stainless SteelWorking rod: 47cmSupport rod: 41.5cmOperating lever: 39.5cmNoodle barrel: 12.5x 5.7cmWeight: 5.6kgNoodle bucket off the ground: 25cmCarton size: 42x 27.5x 13cmOperating space: no less than 80cmFour face cutter heads: 1mm aperture, 2x 6mm aperture, 2mm aperture, 3mm apertureInstallation:Step 1:The whole installation of the noodle machine, first put the base positively, and then align the support rod frame at the position where the base has screw holes.Step 2: After aligning, put the screw on the screw hole, put the screw and then press the screw to roll the base and the support bar together to prepare the screw. When the screw is on, we can focus on it and so on. This ensures the installation process. The stability is good. After tightening the nut, tighten it and put it straight.Step 3: Place the handle on the top of the support bar. Hold the handle of the operating frame with one hand and place the gasket on the top of the support bar with one hand and then put the upper semi-circular nut on the equipped wrench. Instructions:1. When mixing noodles, no matter what kind of noodles, it is best to use warm water and noodles. 2. Loosen the adjusting screw and adjust the operation frame to fit the position of the pot. 3. Remove the noodle bar from the noodle bucket and remove the noodle bucket.4. Replace the cutter head and apply a little cooking oil on it.5. Put the dough in the bucket and put it under the pressing plate.6. Turn the handle to lower the pressing bar until there is no gap with the dough.7. Shake the noodle bar up and down to extrude the noodles directly into the pot.Package:1* Noodle Maker Machine